Sps and revo settings question?

[Markis236]

Ok guys recently had my full timing kit done chain and belt so my problem is since the batter was disconnected my revo remap is know canceld out I have an sps module but never got my settings saved on it !!! I think I know my settings but I want to run it though you guys to make sure it's sound like it's not going to fry my engine I think they are B8 T5 F5 and my other question is since the belt had been done my idles funny all most like a misfire could this be the remap being deleted back to worst than standard ?

Any help would be greatly aprecated and I need my boost back haha

[teo_parvu]

It'd help to know what kind of fuel do you use? What mods do you have? Stage 1,2, 2+, 3?
For example in my stage 2+ Cupra I run with 9 boost, 5 timing, 9 fuel., before the intercooler upgrade i ran with 9-4-9, at stage 2 I ran 7-4-8, etc.   
For a stage 1 GTI i belive u can run 7-6-9 with good pump fuel.

[Markis236]

Sorry forgot the menchon that it's a revo stage 1 for a ko3 turbo with s3 intercooler ,oversized throttle pipe , 3" miltek tbe and a ram air induction kit and I only run super plus unleaded

[Markis236]

So do you think running  8 5 5 will be alright ?

[rich83]

Wonder why fueling is on 5?

[Markis236]

I don't now I've looked at other peoples fueling and they all seem to be about 9 :/

[Dan_FR]

Fuel is usually set to 9 as the hpfp struggles in the midrange with any more.

You need VCDS to check the cam timing and for data logging before you start playing with the SPS. Boost 6 Timing 5 Fuel 9 should be OK on Vpower but you need VCDS

[Markis236]

That's the problem vag com has been on my shopping list for some time know but to playboy safe just put the settings you have given me till I take it back to revo or just got r-teck

[Dan_FR]

Vcds clone for 20 quid would do the job if money is tight. A revo dealer will charge for setting it back up mind.

[Markis236]

I thought setting it up was free if you bought the map ? And where can I get one of these clones and are they any good ?

[Markis236]

Ok iv just plugged my sps in and tried to adjust the setting but it won't let me it comes up on my computer sps not supported any ideas wtf this means -.-

[Dan_FR]

They set it up at the time, not free each time going forward

Screenshot & more info needed

[Markis236]

I may as well got stage 2 and pay the difference between both maps then !

[Hedge]

Before you do anything I would get the idle misfire resolved.

[Markis236]

Fault code ready determined it was a camshaft sensor so going to scrappy tomorrow to find one if any one knows any cars that have the same sensor like seat lean fr and stuff would be great