New Flywheel and Clutch, can't get into gear.

[r5gtt]

Progress 

Dont know how you managed to under tighten those bolts 

[ChazGTI]

All Sorted! Can't believe it was that.

Can't look over the basics!
Not sure how I managed to under tighten them that badly, but then again I didn't have a torque wrench that fitted the 12 point socket so I had to improvise.
Lesson learned!

Thank you all for the fantastic help and suggestions 

[Dan_FR]

Great news. Hope they're tight enough now, big of thread lock is normally a good idea

[xjay1337]

Well as @Dan_FR had pointed out, I had under-tightened the PP bolts. Just finished slowly tightening them through the starter hole while a friend rotate the crank.

Tested the clutch and now the PP stays still like it should. Gonna put everything back together and HOPEFULLY all will be good.

Result!!! :-)

[ChazGTI]

Great news. Hope they're tight enough now, big of thread lock is normally a good idea

Yep used some loctite blue!

Man, the difference in a new clutch and flywheel after the state mine were in is so bloody nice!