All Things Mk5 > How to Guides / Troubleshooting

Potential Milltek Turbo Back Exhaust Installation Issue

<< < (2/3) > >>

xxx_mojo_xxx:

--- Quote from: RedRobin on January 21, 2010, 10:10:47 am ---....

Unfortunately I don't have any underside pics of my Milltek in that area, but it does look somewhat unsupported in your pics.

Who installed it?

--- End quote ---

TTS Roadsport - I've asked them to raise the issue with Milltek as they did the installation. 

They have said that they have seen "variations" in the past supposedly for the same bit of kit which may account for the less than perfect fitting.

Let's see what Milltek and TTS comeback with...

MAT ED30:
this is how my blueflame sits lots higher

RedRobin:
^^^^
Looks like your Blueflame is rigidly fixed rather than suspended in rubber hangers which allow for heat expansion etc, Mat  :surprised:

xxx_mojo_xxx:
Thanks Matt..  

Just to go off on a bit of a tangent.  Are those eibach ARBS - and are they on the aggressive setting?    :drool:

I've got mine set to the soft setting front and rear.

Is there a noticeable difference between the two settings - what's the recommended setup?

P.S.  I really should be working!!!

MAT ED30:
can u not see the rubber oe hanger it sits in Robin  :laugh: u need race mounts  :P stops it moving at all  :P

Navigation

[0] Message Index

[#] Next page

[*] Previous page