Hose Clip Pliers - HELP

[jaylufc17]

Trying to install ram air induction

any one got a link to which is the correct tool to take the pipe out (inlet pipe to turbo i think)

this is the pipe i am trying to take out (ideally halfords/screwfix/b&q/carspares) so i can do it today
http://i49.tinypic.com/nyfxib.jpg

[slix]

Something like these should do it

http://www.halfords.com/webapp/wcs/stores/servlet/ProductMobileDisplay?catalogId=10151&langId=-1&categoryId=318447&productId=1162351&storeId=10001

Although using screw tightened jubilee clips after down there makes it so much easier getting them on and off in future as it's such a tight squeeze getting down the back.

[jaylufc17]

thanks will give this a try now... got them pliers already

[rich83]

Mole grips are good because you can set them to lock and then jiggle it to remove the clamp.

[jaylufc17]

Ok so managed to remove the clamp but seems there's another black clamp which preventing me pulling the pipe out??? I can't see anywhere to clamp onto though??









Sent from my iPhone using Tapatalk

[slix]

^^ that's just a rubber bung seal and just pulls out.

[jaylufc17]

lol my bad! i aint got a clue so i can just yank this off basically..

[jaylufc17]

lol my bad! i aint got a clue so i can just yank this off basically..

Woo hoo it's off


Sent from my iPhone using Tapatalk