Boost pipe map sensor

[Geomac901]

Hi folks,

Could anyone tell me the wires for the map sensor on the boost pipe /intercooler charge pipe?

The sensor has been botched and crimped and the crimps have been plugged into the pins of the sensor and now I that I have a proper plug I'd like to do it properly: solder and heat shrink the new cables.

Looking around on the web I have managed to find that the 4 pin plug only uses 3 pins. Pin 2 is missed out.
1 is ground.
3 is 5 volts.
4 is the signal sensor.

What wires correspond to the correct pins? I have 3 wires: black, orange and pink/green.

Any help would be great.

George

Sent from my ONE E1003 using Tapatalk

[SpudGTI]

Hi bud have you sorted this i have same problem and need to knkw what wire goes to what pin

Sent from my SM-G935F using Tapatalk

[SpudGTI]

Not sure if its rite but ive put

Black 1
Orange 3
Pink/green 4

Hope its rite but we will see once i get a code reader on it

Sent from my SM-G935F using Tapatalk