Make a donation
« previous next »
Pages: 1 [2]   Go Down

Author Topic: H&R roll bar brackets needed from where?  (Read 3236 times)

Offline r5gtt

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 342
  • -Receive: 334
  • Posts: 5586
Re: H&R roll bar brackets needed from where?
« Reply #15 on: September 05, 2017, 12:56:15 am »
My temp fix nut job  :signLOL:

« Last Edit: September 06, 2017, 06:32:46 pm by r5gtt »
Logged

Offline Pesky jones

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 2
  • -Receive: 19
  • Posts: 1639
Re: H&R roll bar brackets needed from where?
« Reply #16 on: September 06, 2017, 09:15:00 am »
Yeah looks like mine. Did you have to square an edge of the washer like I did mine
Logged

Offline Pesky jones

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 2
  • -Receive: 19
  • Posts: 1639
Re: H&R roll bar brackets needed from where?
« Reply #17 on: September 06, 2017, 09:15:32 am »
Checking the photo again I can see you didnt.
Logged

Offline r5gtt

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 342
  • -Receive: 334
  • Posts: 5586
Re: H&R roll bar brackets needed from where?
« Reply #18 on: September 06, 2017, 06:32:23 pm »
It's not a washer but built in to the nut.
Logged
Pages: 1 [2]   Go Up
« previous next »