Painted my grills - great results

[shail]

Decided to paint my grill and fog surrounds.

Bought bumper paint from Amazon - Autotek spray can. This stuff stinks - I sprayed in the garden, I wouldn't recommend using this spray indoors / in garage.

Results are good - grey is now black! 



[img width= height= alt=IMG_20180612_204755" border="0]https://preview.ibb.co/gJFtvJ/IMG_20180612_204755.jpg[/img]

[Nardoblue]

Results looks fantastic, thanks for the heads up on the smell. One of those jobs that mak the car look fresh again

[shail]

Results looks fantastic, thanks for the heads up on the smell. One of those jobs that mak the car look fresh again

Further heads up: if your car is anything like mine the clips are very brittle on the grills and badges. Managed to break quite a few, and I was being careful.

Also, there are 4 screws holding the top part of the grill- 2 at top and 2 at bottom.  I didn't see the bottom ones so broke the bottom clips.

[Caspersmith]

Results looks fantastic, thanks for the heads up on the smell. One of those jobs that mak the car look fresh again

Further heads up: if your car is anything like mine the clips are very brittle on the grills and badges. Managed to break quite a few, and I was being careful.

Also, there are 4 screws holding the top part of the grill- 2 at top and 2 at bottom.  I didn't see the bottom ones so broke the bottom clips.

Looking good, cheers for heads up. Mine desperately need doing.

Sent from my SM-G950F using Tapatalk

[Chesto18]

Looks great. How many cans did it take? Does it just go straight on?

[shail]

Looks great. How many cans did it take? Does it just go straight on?

Used less than 1 can to do the grills and the fog surround.   The can is 500ml, so bigger than the normal rattle cans you buy in Halfords.

I just cleaned the grills with soap - needed to scrub inside each hole as there was moss growing in each of the 'corners', then sprayed straight on.  Can says no primer needed, but looking at the data sheet it recommends a 'adhesion promoter' - whatever that is!  Time will tell if it stays stuck, but for £8 im not worried.

Took a few coats and had to spray at lots of angles to get at each side of the hexagon shapes.

[GTIEagles]

Good call. I was thinking about doing something similar to mine as it ages the car so badly!

Does it leave a hard finish? How did you remove the red trim from the grill?

[Dogma]

Looking good


Sent from my iPhone using Tapatalk

[shail]

Good call. I was thinking about doing something similar to mine as it ages the car so badly!

Does it leave a hard finish? How did you remove the red trim from the grill?

Finish is like a normal paint.  I masked off the red line as I don't think it's easy to remove.

[Chesto18]

Just bought a can. Let’s see what happens!

[pudding]

Nice one!  Definitely makes a difference.  I notice most current VAGs have a glossy finish on the grilles, so maybe they are finally catching on that plastics don't stay black for ever!

[shail]

I've managed to totally muller the Gti badge on the grill.  Going to have to fix it somehow, as I'm not paying £25+ for a new one!

Broke all 3 tabs on it - going to try super glue + baking soda trick.

[WarrenVrs]

Is it a bumper off job to remove the grills? Most of the cars I've looked at have the grey, faded grills

Sent from my ONEPLUS A6003 using Tapatalk

[Sessions]

Great job

[shail]

Is it a bumper off job to remove the grills? Most of the cars I've looked at have the grey, faded grills

Sent from my ONEPLUS A6003 using Tapatalk

No.

Top part of grill:
Open bonnet.
2 screws to remove at top of grill - torx ones
2 screws just below never plate
Then it will pull out as it's clipped in - just be careful and try and find where clips are.

Bottom part
Clipped in top and bottom. You can get a screwdriver behind to push the tabs down.

Fog grill:
1 screw in each covers then just pulls off.