Hello guys,
Bought a Carly adapter and scanned the car which gave me the below:
The car hasn't got any symptoms (that I noticed
) apart from when I was full throttle going through gears on gear 4 it went into limp mode but then it worked normally on lower gears. My thought was that when the load is high the pump loses pressure?
I also did some live testing with Carly but I am not sure what I should be looking for exactly. Below is what I did. (Measurements below are somewhere around 2600-3000rpm)
Can someone tell me what are some proper values for this car? What should I be measuring for this kind of fault etc? It's got a stage 1 remap so some values might be a bit higher that factory.
Bear in mind that around 600miles ago the car had a rebuild - new pistons, timing chain, etc.
