Crazy quote for brake dust sheilds?

[chowgar]

Fronts don’t need the hubs coming off but disc will the rears will or cut them to fit around

[chigmuss]

Rub back and paint obvious rust and sandwich some massive washers over the holes that have rusted out and bolt them back down again

[shail]

Started this today.  Didn't get far as I couldn't find my stubby triple square M14 socket, but found the longer one which I know is too long.  Lost all my patience within 2 mins of not finding the socket and then attacked it with a Dremel, which wasn't really successful.

Going to go at it with some tin snips tomorrow - it's so rusted it's flapping about so think I can get in there with some snips.  Basically going for a bodge!

[probedb]

Started this today.  Didn't get far as I couldn't find my stubby triple square M14 socket, but found the longer one which I know is too long.  Lost all my patience within 2 mins of not finding the socket and then attacked it with a Dremel, which wasn't really successful.

Going to go at it with some tin snips tomorrow - it's so rusted it's flapping about so think I can get in there with some snips.  Basically going for a bodge!

If you're just removing, tin snips will work fine, that's how I got both of mine off 

[shail]

Yes, just removing them for now.  Need to buy some tin snips though!
  Would these be man enough? https://www.screwfix.com/p/aviation-tin-snips-set-3-pack/2941v

[pandaman]

Had the same problem, rusted through all screw holes and hit a pot hole thing was completely loose and rattling around. Used tin snips too, mine looked like these

https://www.toolstation.com/irwin-gilbow-general-purpose-snips/p60793

Still haven't replaced them, have new ones waiting, I'm thinking I will put them on when I next do discs and pads. Really can't be assed with taking the hubs off so I will cut and paint the new ones

[shail]

All done.  I bought the 3 pack of snips and they worked well.  No more rattling.Thanks all for your help.