Hi Folks,
After daily driving my mk5 for a few years, about a year ago I took it off the road to sort out a few spots of rust.. I started off thinking it’d probably be a new wing and a small patch repair on the sills. A year later I’m getting ready to put it back on the road after a fair bit of work! I’ll share some pics below…
It started with a few spots of rust on the surface of the sills and one wing.. but once I got the paint off the rust was far worse than it looked.
Once the sill covers and under-trays, arch liners were off I stripped back the paint with a wire wheel and the rust was way worse than expected.
There were several holes in the sills and the rear of the sills where dirt had gotten stuck behind the arch liner.
To get access and also to inspect the extent of the rust further I dropped the rear subframe, which looked like it had been sitting in a canal..
I also dropped the fuel tank to get better access and to avoid any accidents when welding!
Underneath was mainly surface rust.. but it still took a few long days with a knotty wheel on a grinder to shift it. Once removed I covered in rust protection and some acid etch…
I decided because of a couple of holes and a fair bit of surface rust to cut the sills off and weld on new ones. I decided to keep the top half and weld the new ones below the line of the sill covers.. only coming up at the very front and back edges where the rust was bad…
I’m glad I did as once cut off they were pretty crusty inside.. thankfully the inner sills were pretty solid and I only had to patch two small areas. Here is a photo mid weld…
The sills were fully welded and primed.. it’s worth noting, I decided to remove the interior during all of this to avoid any chance of it catching fire or being damaged by sparks etc.
With that done, I couldn’t exactly put on the old subframe.. so I set about finding a new (old) subframe and got a bit carried away buying alloy hub carriers and wishbones etc
…and brakes and suspension and a big bag of bolts from tps (some out of necessity for the alloy hubs)…
With the subframes refurbed and fitt d with new bushes etc. it was time to clean the underside one last time and give it a few coats of Upol
I’ve now got the subframes back on and it looks like everything fits..
I’ve replaced pretty much everything so it is looking nice and shiny!
Last things below the car are finish fitting all these bungs and make up new brake lines.
Above the underside still have loads to do, finish sanding and filling paintwork, paint the whole car, fit the interior etc.
If you have any questions about anything above I have several hundred other photos and I think I can remember most of what I did. I should also note, this was my first time taking on a project like this having never welded before and I had to teach myself as I went.. hence it taking about a year. I also work full time and have a family, so I only get the odd evening to work on it.
I’m looking forward to driving it again in the near future.