Attempted to fit my folding mirrors with puddle lights over the weekend, and it didn't go as planned
Removing the door trims and the old mirrors was fine, plenty of guides on the net
I recommend using a magnetic torx bit otherwise there is a high risk of dropping the bolts for the mirrors into the interior of the door, never to be seen again
As mine is a MY08 car I needed 3 GEN controllers
so I picked up the following
1K0959701N - drivers door
1K0959702AG - passenger door
In VCDS on both modules there is the long coding to enable folding mirror (for MY08) cars (this option isn't available/needed for 2 GEN controllers and I haven't seen any mention of it on any forum)
On the 1K0959702AG it accepted the coding for folding mirrors
Installed the passenger mirror, but when folding it goes forwards and not into the car and doesn't appear to lock into position when in the normal mirror position, I'm sure it was fine before attached to the car
When trying to enable folding mirror on the drivers controller 1K0959701N, it fails, coding not accepted
, apart from not folding the mirror appears to be fine and doesn't suffer the 'loose' action of the passenger mirror
On a plus point the puddle lights look pretty good, just need non yellow bulbs
Going to have to take another look at the passenger mirror, and investigate further the drivers controller
And apologies to Scott, I wasn't in the mood to talk to anyone after discovering all these problems after spending so obtaining all the parts