What Settings Could I Run With Revo Stage 1 If I Got A Fuel Pump??

[Phil_T]

Did some logs other nite on what revo set B6 T6 F9 the Cylinder Timing was -6!!! on one cylinder it was also on -5 too

I would start on settings B6 T4 F6 and if all is ok then start gradually increasing them 1 step at a time

Are you saying start off on that with a standard fuel pump or uprated one? As i now have the autotech pump fitted

[vRS Carl]

Yes start of on that with a standard or HPFP.

It's better to start safe and gradually increase than go the other way

[Phil_T]

Yes start of on that with a standard or HPFP.

It's better to start safe and gradually increase than go the other way

Cheers, will do doing some logging today before I set off to Modball next week!

[Phil_T]

Did some logs today and ended up having to stick with B7 T5 F7 with a little pull back on one of the cylinders for a few seconds. Tried upping the boost to 8 which felt alot better but it was pulling back quite abit :(

Do you think its because ive still got standard exhaust and stage 1 map?

[vRS Carl]

It could be any no. of reasons.

IIRC when i first went on to Stage 1 i was on settings B7 T5 F7 so that sounds about right

You could try lowering the fuel setting to 6 and seeing if you can up the boost then. To be honest though it wont gain you much going up one boost level - maybe 5bhp & 5-10 lb/ft.

If you want me to have a look at the logs just PM me and i'll give you my email