Make a donation

Author Topic: Rear geometry setup.  (Read 1040 times)

Offline nc35

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 40
  • -Receive: 14
  • Posts: 702
Rear geometry setup.
« on: June 12, 2010, 11:12:00 pm »
Hi All
Remember reading about a "softer" geometry setup for the rear.
Improves tyre & bearing wear, tyre noise etc at the slight expense of the sharp handling.
Anyone got the details. Going for a four wheel allignment this week and was tempted to ask for these settings.
Cheers.
Lee 
No Golf anymore. 
Enjoyed the last five years of ownership of Mk5 & 6 GTIs.
Plus an excellent forum for knowledge and new ways to deplete the bank account.
Thank You Everyone.

Offline alex_chung

  • Always Involved
  • ****
  • Thank You
  • -Given: 0
  • -Receive: 0
  • Posts: 92
    • Email
Re: Rear geometry setup.
« Reply #1 on: June 13, 2010, 10:38:55 am »
I think there was a Technical Bulletin that came out for Skoda that had the correct setting. You can see them here (Guide by our own vRStu I think)
Otherwise there is a good thread on here at SeatCupra.Net.
Hope this helps.
Alex

Offline nc35

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 40
  • -Receive: 14
  • Posts: 702
Re: Rear geometry setup.
« Reply #2 on: June 13, 2010, 04:57:24 pm »
So can the GTI run the same as the Octavia?
-1'20 +/- 30?

Any detsils on the TSB?
No Golf anymore. 
Enjoyed the last five years of ownership of Mk5 & 6 GTIs.
Plus an excellent forum for knowledge and new ways to deplete the bank account.
Thank You Everyone.