Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: help needed fitting Pipercross viper please...  (Read 1944 times)

Offline Pullafacial

  • Always Involved
  • ****
  • Thank You
  • -Given: 0
  • -Receive: 1
  • Posts: 74
    • Email
help needed fitting Pipercross viper please...
« on: July 05, 2010, 03:59:27 pm »
Hi all,

I fitted my viper induction kit this afternoon but can't see where to route the pipe to get a good cold air feed.
Currently i'm running it without the pipe so guess i'm sucking up loads of warm air.

Also, I expected it to give my engine a bit more of a "gruntier" sound but it sounds pretty much the same.



Any help appreciated...

Logged

Offline MAT ED30

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 25
  • -Receive: 82
  • Posts: 5728
  • Vwr fan boy
    • Email
Re: help needed fitting Pipercross viper please...
« Reply #1 on: July 05, 2010, 04:49:54 pm »
did u take the filter out of the stock engine cover first ? and just put the air feed down to the nsf foglight cover but cut some holes in the cover
« Last Edit: July 05, 2010, 04:54:21 pm by MAT ED30 »
Logged

Mods yes but way too many to stick in this little box

Offline Pullafacial

  • Always Involved
  • ****
  • Thank You
  • -Given: 0
  • -Receive: 1
  • Posts: 74
    • Email
Re: help needed fitting Pipercross viper please...
« Reply #2 on: July 05, 2010, 05:24:09 pm »
Yeah took stock filter out, will try and route down to foglamp.
Not sure if I like the idea of cutting holes though!
Logged

Offline MAT ED30

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 25
  • -Receive: 82
  • Posts: 5728
  • Vwr fan boy
    • Email
Re: help needed fitting Pipercross viper please...
« Reply #3 on: July 05, 2010, 05:44:21 pm »
just drill some of the little cut outs in the foglight covers out  :smiley: nice and easy to do
Logged

Mods yes but way too many to stick in this little box
Pages: [1]   Go Up
« previous next »