Interesting day on the rollers

[big_pete]

Had a testing day today on the rollers with my mk4 1.8t
Ran the car as standard and then did power runs with jetex intake, K & N intake and then Jetex cat back system
Running 176bhp standard airbox and exhaust
jetex intake gave 6 bhp more and smooth torque curve
K& N intake gave 4 bhp and not so smooth
Jetex exhaust , cat back gave very little bhp rise but torque increased at higher revs
Tried a remap with jetex exhaust and intake looking for 200 bhp plus boosting at 1.2 bar
but we car wouldnt boost, so went back to standard map , and then it wouldnt start ! a bit confused
As we found, the car had previously been superchipped and there map had stopped all changes, so that was a lesson.
we will get round this , and I look forward to 200 + bhp next week
I will post some pics up later

[PDT]

Tried a remap but car wouldnt boost, so went back to standard map , and then it wouldnt start ! a bit confused
As we found, the car had previously been superchipped and there map had stopped all changes, so that was a lesson.
we will get round this , and I look forward to 200 + bhp next week

This is always a problem when using remapping tools that only write the data area and not the entire flash memory. Does the tool ask you if you want to complete a full or partial read/write? if so choose full and you shouldnt have any problems 

[big_pete]

Thanks for the reply dave, I think we got it sorted, back on the rollers next week for anouther go, and hopefully testing the milltek exhaust.
You mentioned about a wholesaler for performance parts , who was that ?