Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: Kenwood ignition issue  (Read 1184 times)

Offline Lyons

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 18
  • -Receive: 26
  • Posts: 1090
    • Email
Kenwood ignition issue
« on: September 09, 2010, 09:21:44 pm »
Just tried fitting a kenwood DDX unit but it wouldn't switch on/off using the key, just via the power button at the front.

Before anyone suggests it, yes I did try swapping the red and yellow wires!!! But to no avail.

I have a Parrot ck3100 fitted too, so I even tried it with the Parrot loom removed, but made no difference.

Anyone any ideas? So close yet so far!
Logged

Offline vRStu

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 90
  • -Receive: 159
  • Posts: 2562
    • Octavia-vRS Information Resource
Re: Kenwood ignition issue
« Reply #1 on: September 09, 2010, 09:41:15 pm »
The VW doesn't have a switched ignition live at the quadlock.  That's your problem.

The OEM units are switched on and off using CAN commands.
Logged
Stu...

Quartz Grey Audi A4 3.0 TDi S-Line Quattro, 7 Speed S-Tronic, 19" Twin Spoke Alloys, Alcantara Upholstery with Silver Stitching and Heating, Sat Nav High, B & O Sound, Audi Music Interface, DAB Radio, Parking Advanced with Rear View Camera, Advanced Keyless Entry, LED Interior Light Pack, Hill Hold Assist, Heated and Electrically Folding Mirrors, Through Load.

RNS510 Video in Motion unlocking, PIN recovery & DVD Region Free available

Offline Lyons

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 18
  • -Receive: 26
  • Posts: 1090
    • Email
Re: Kenwood ignition issue
« Reply #2 on: September 09, 2010, 10:01:20 pm »
So I read.

I think I'll have to tap into the fusebox feed for the parrot and connect it to the red ignition on the HU loom.
Logged
Pages: [1]   Go Up
« previous next »