Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: Interior "kneepad"  (Read 2723 times)

Offline liver

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 14
  • -Receive: 15
  • Posts: 980
Interior "kneepad"
« on: September 30, 2010, 10:04:34 am »
Im wanting to know if its possible to remove the 'kneepad' parts on the interior and if so how are they removed?
heres a pic of the area in question.
i know osir do a carbon part but not sure if they goes over the top of the original or if the original is removed and replaced by the carbon.



cheers for any help
Logged

Offline Richn83

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 49
  • -Receive: 85
  • Posts: 1883
Re: Interior "kneepad"
« Reply #1 on: September 30, 2010, 11:08:13 am »
That bit is easily removed, you need to be careful not to break the retaining clips which are plastic, and its removed by prying it out with a trim removal tool (or very carefully with a flat headed screw driver and some protection)
Logged

5Dr Black GTI, DSG, Leather, Xenons. Retrofitted - Cruise, RNS 510, MFSW, Armrest, Skoda BT, 6cd changer, Monza II's, VW speaker upgrade kit, Lux pack, High-line, new CAN gateway, Polar FIS info display, R32 tinted rear lights, RVC

To Come...NQSBBK, highline CCM.

Offline liver

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 14
  • -Receive: 15
  • Posts: 980
Re: Interior "kneepad"
« Reply #2 on: September 30, 2010, 11:14:55 am »
so its not held in by any torx screws or anything, is it just two clips per side?
Logged

Offline Garth

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 4
  • -Receive: 14
  • Posts: 605
    • My Build thread
Re: Interior "kneepad"
« Reply #3 on: September 30, 2010, 11:22:50 am »
As far as I can remember, it is only clipped in place, but I had to remove half the centre console to get those bits loose enough to come out!
Logged

Offline liver

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 14
  • -Receive: 15
  • Posts: 980
Re: Interior "kneepad"
« Reply #4 on: September 30, 2010, 11:25:02 am »
ive already got half out and sure the clips can be seen, will give it a bash


cheers for the information people
Logged

Offline Richn83

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 49
  • -Receive: 85
  • Posts: 1883
Re: Interior "kneepad"
« Reply #5 on: September 30, 2010, 12:03:26 pm »
Pretty sure they clip out without screws, they mask off some torq screws for some of the rest of the trim on the center tunnel, one of mine is loose on the drivers side due to a broken clip so it cant be held in too firmly!
Logged

5Dr Black GTI, DSG, Leather, Xenons. Retrofitted - Cruise, RNS 510, MFSW, Armrest, Skoda BT, 6cd changer, Monza II's, VW speaker upgrade kit, Lux pack, High-line, new CAN gateway, Polar FIS info display, R32 tinted rear lights, RVC

To Come...NQSBBK, highline CCM.

Offline dan_gt

  • Always Involved
  • ****
  • Thank You
  • -Given: 0
  • -Receive: 0
  • Posts: 70
    • Email
Re: Interior "kneepad"
« Reply #6 on: October 06, 2010, 07:12:58 pm »
Can these be replaced wutg TT ones?
Logged

Offline 182_blue

  • Global Moderator
  • Just look at my post count
  • *
  • Thank You
  • -Given: 20
  • -Receive: 54
  • Posts: 3373
Re: Interior "kneepad"
« Reply #7 on: October 08, 2010, 07:28:05 am »
If you check the website you will see it says they are bonded onto the originals, you will also see that the actual part has been discontinued by Osir too

Quote from: liver on September 30, 2010, 10:04:34 am
Im wanting to know if its possible to remove the 'kneepad' parts on the interior and if so how are they removed?
heres a pic of the area in question.
i know osir do a carbon part but not sure if they goes over the top of the original or if the original is removed and replaced by the carbon.



cheers for any help

Logged
Pages: [1]   Go Up
« previous next »