All Things Mk5 > Revo Zone

HELP - Select Switch Software - does anyone have it to upload?

(1/2) > >>

berg:
Hello chaps, bought a now obsolete Select Switch off h4rdy when got Revo as dont really think I will need SPS.

Now both Revo dealers I have seen have not been too helpful in putting my settings onto the switch and h4rdy's too aggressive settings for me are still on it.

Went to Revo site to d/l software as Rob at Revo suggested I could do this.

However, it recognises that the switch is not an SPS and wont let me d/l the software.

So basically I need someone to send me the old software so I can finally use the switch, failing which will have to speak to Revo and maybe post it to them and ask them to sort this out for me.

any help much appreciated (unless you wanna by switch back J? :wink:)

stealthwolf:
Havd you tried contacting Revo HQ rather than relying on dealers?

berg:

--- Quote from: stealthwolf on January 06, 2011, 03:44:36 am ---Havd you tried contacting Revo HQ rather than relying on dealers?

--- End quote ---


nope that is next port of call, someone has sent me software not had time to try it yet.

J - ha ha i might work up to boost 9 when my balls have grown a bit  :jumping:

berg:

--- Quote from: h4rdy on January 08, 2011, 07:53:00 pm ---Have a look at the settings on the back of the instructions I am not sure if they are boost 9?

--- End quote ---


you have scribbled out your older settings and put your newer ones on which says 9.

looks like i will have to speak to revo direct about this and see if they will set it for me

muckipup:
I had the same problem with the previous Select Plus switch.  I downloaded the software but without luck and ended up having to use the CD that came with the switch.

I can now connect to the switch OK but have a further problem where the switch will not recognise the ECU now and my previous post here with Revo Supports solution did not work

Navigation

[0] Message Index

[#] Next page