13-GTIain
I'm definatly interested but as big al says its dependent on price. Also what kind of time scale are we looking at?
....As I said when I started the list: Adding your name to the list does not commit you to a price which none of us know yet - It's to gauge a PCB quantity to order and therefore get the most favourable rate.
If you read through this read, especially cmdrfire's Reply #29, you'll see that we don't yet know how long either but we are doing all we can and it is most likely going to take a long time:
cmdrfire:
Please bear in mind that it may be a little while before we get these - We've got to look at what sort of data we have to work with, I've got to design and lay out the PCBs, then we will get some one- or two-off prototypes made and assembled (which will probably be fairly expensive, maybe £50/side as a rough guess as there'll be machining work to be done etc). After that they need to be tested off the car, then on the car, and make sure all the functionality works as intended. After that we can got to a batch PCB house in China and get a whole bunch made for everyone, that will be a much more reasonable cost but the downside is that the batch processing will take some time (IIRC used to be 14-30 days, but may be less now).
After they come back, they'll have to be assembled, and tested, and then (being an auto engineer) I think I'd insist on a conformal coat to protect them, btu that shouldn't take too long.
The end goal will be for some inner tail LEDs that will be reasonably priced, built to near-automotive standard, and capable of a variety of functionality - "normal" operation (on with sidelights/dipped lights), brake functionality (if desired), and fog-lamp functionality (if desired) with the two inner filament lamps being used for reversing lights. No point messing about with half-assed fixes and electronics that will break over time.
We will keep this thread updated on progress. I hope this helps.
