Make a donation
« previous next »
Pages: 1 [2]   Go Down

Author Topic: Engine mounts and Front and Rear Anti Roll Bars??  (Read 3355 times)

Offline vRS Carl

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 282
  • -Receive: 240
  • Posts: 3088
  • I'm the F.A.G (Forum Apple Guru)
Re: Engine mounts and Front and Rear Anti Roll Bars??
« Reply #15 on: May 02, 2011, 11:55:29 am »
Noise and also stops the engine flexing in the bay which can put stress on things like turbo down pipes etc
Logged

Offline danishmkvgti

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 243
  • -Receive: 154
  • Posts: 3680
    • Email
  • My Ride: http://www.mk5golfgti.co.uk/forum/index.php/topic,7823.0.html
Re: Engine mounts and Front and Rear Anti Roll Bars??
« Reply #16 on: May 02, 2011, 12:00:34 pm »
There's quite a lot of slack in the oem ones so to tighten everything up and prevent wheelspin, uprated engine mounts is a must  :wink:
Logged

Over the top mod list ;o)

Offline RobH

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 3
  • -Receive: 9
  • Posts: 581
  • Revo stg 2+
Re: Engine mounts and Front and Rear Anti Roll Bars??
« Reply #17 on: May 02, 2011, 02:11:08 pm »
I have BSH side mounts and THS lower mount. There not intrusive and transmit a good sound into the cabin.

Benefits are pretty much no wheel hop and reduced wheel spin, very little engine movement if at all and therefore better gear changes and no broken exhaust downpipes and as above tightens everything up at the front.
Logged

Offline garrardrj

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 76
  • -Receive: 42
  • Posts: 1098
  • EX 2007 Golf Edition 30 owner in Suffolk
    • Email
Re: Engine mounts and Front and Rear Anti Roll Bars??
« Reply #18 on: May 03, 2011, 11:43:44 am »
Can someone post a link to the engine mounts that need replacing to improve the gear change as its quite poor for such a nice sporty car (Edition 30) . Is it a DIY job?
Logged
2015 Golf R White 5 Door Leather DCC Dynaudio Pretorias
2009 Land Rover Freelander HSE - Workhorse
2007 Mk 5 Golf GTI Edition 30 - SOLD

Offline danishmkvgti

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 243
  • -Receive: 154
  • Posts: 3680
    • Email
  • My Ride: http://www.mk5golfgti.co.uk/forum/index.php/topic,7823.0.html
Re: Engine mounts and Front and Rear Anti Roll Bars??
« Reply #19 on: May 03, 2011, 11:51:18 am »
Logged

Over the top mod list ;o)

Offline Mackie1

  • Always Involved
  • ****
  • Thank You
  • -Given: 22
  • -Receive: 6
  • Posts: 205
Re: Engine mounts and Front and Rear Anti Roll Bars??
« Reply #20 on: May 05, 2011, 12:58:48 pm »
Uprated engine mounts are an absolute must and one of my best mods. They go hand-in-hand with any serious power increases you're planning to make. I went for the full VWR set-up (Side engine mount, Transmission mount and Lower engine mount) however by all accounts the THS mounts will do the same job. Highly recommended.  :wink:
Logged
Pages: 1 [2]   Go Up
« previous next »