Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: Advice needed for clock/dials removal HELP!!!!!!!!!  (Read 7311 times)

Offline daboy3000

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 8
  • -Receive: 9
  • Posts: 599
  • MKV GT TDi
Advice needed for clock/dials removal HELP!!!!!!!!!
« on: April 11, 2011, 10:47:33 am »
My LCD display in the centre of my dials is on it's way out, I have sourced another set of tdi clocks cheap.  I would like to replace the whole unit but I believe that some coding would need doing.  Is it possible just to replace the LCD screen?

I have searched but I ca't find a guide to removing the unit from the dash, I know many people have upgraded to highline so hopefully someone can point me in the right direction.

Any help with this would be great.

Cheers
« Last Edit: April 13, 2011, 01:12:46 pm by daboy3000 »
Logged

Offline apollo13

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 2
  • -Receive: 47
  • Posts: 1017
Re: Advice needed for clock/dials removal
« Reply #1 on: April 11, 2011, 12:29:23 pm »
Its easy.

Lower and pull the steering wheel to its furthest point. Remove the trim with the fabric flap by pulling up and out carefully as you can snap the clips.

Then remove the 2 torx screws under the cluster and wiggle out. Once out split the cluster into its 3 parts- cover,dials and lcd screen and back portion with the memory board by unclipping the clips around the cover and removing the 2 torx screws in the back of the cluster.

Do this for both clusters and just swap the new lcd/dial portion with your old back/memory portion and replace the cover. Slide back in and you shouldn't have to do any coding at all.

Logged
****Registered VCDS HEX CAN Kent Area For All Retrofits**** GT TDI - Retro fitted by me so far.... OEM Omanyts - Sportlines - GT Sport Front End - GTI Rear and Skirts - Hella Dynabeam Xenons - Heated Leather - Highline Cluster With White LED's and Lit Needles - Armrest - Mk6 GTI MFSW - Skyline OEM LED Tailights - LED RNS 510 With Voice Control - Rear Sensors - 729B Bluetooth - Highline CCM + CECM - AF CAN Gateway - Cornering Fogs - U.S Indicators

Offline daboy3000

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 8
  • -Receive: 9
  • Posts: 599
  • MKV GT TDi
Re: Advice needed for clock/dials removal
« Reply #2 on: April 11, 2011, 01:40:09 pm »
Wicked, cheers Apollo
Logged

Offline daboy3000

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 8
  • -Receive: 9
  • Posts: 599
  • MKV GT TDi
Re: Advice needed for clock/dials removal
« Reply #3 on: April 13, 2011, 01:12:33 pm »
Ok, did what you said with no probs but as soon as I plugged it back into the car lots of lights are flashing up!!! any ideas?

EDIT:

They are slightly different, so maybe my rear is incompatible with the newer front.  The LCD's have different connections.

Put my old one back together and now the LCD isn't working and the steering wheel light and the traction control lights are stuck on!!!

Sometimes I wish I never started!!!
« Last Edit: April 13, 2011, 01:43:33 pm by daboy3000 »
Logged

Offline alexperkins

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 7
  • -Receive: 99
  • Posts: 2122
Re: Advice needed for clock/dials removal HELP!!!!!!!!!
« Reply #4 on: April 13, 2011, 01:51:03 pm »
Drive a little...the steering wheel and TCS lights should clear

They have to self test  :happy2:
Logged


VCDS Scanning/Coding, RNS and MDI retrofits, and specialist mechanics services with VAGtek available - Just PM me for details.

Offline daboy3000

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 8
  • -Receive: 9
  • Posts: 599
  • MKV GT TDi
Re: Advice needed for clock/dials removal HELP!!!!!!!!!
« Reply #5 on: April 13, 2011, 01:57:11 pm »
Ok, cheers.  I guess i'm going to have to take it apart the lcd and see if it's not connected correctly.
Logged

Offline apollo13

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 2
  • -Receive: 47
  • Posts: 1017
Re: Advice needed for clock/dials removal HELP!!!!!!!!!
« Reply #6 on: April 13, 2011, 05:31:01 pm »
What year is your car and what year is the new cluster??

Are they both def midline? Are you sure the new one isn't lowline?? They look the same.......

Post the part numbers of both clusters.

I've pulled my cluster out a hundred times and never had to reset any warning lights.
« Last Edit: April 13, 2011, 05:33:12 pm by apollo13 »
Logged
****Registered VCDS HEX CAN Kent Area For All Retrofits**** GT TDI - Retro fitted by me so far.... OEM Omanyts - Sportlines - GT Sport Front End - GTI Rear and Skirts - Hella Dynabeam Xenons - Heated Leather - Highline Cluster With White LED's and Lit Needles - Armrest - Mk6 GTI MFSW - Skyline OEM LED Tailights - LED RNS 510 With Voice Control - Rear Sensors - 729B Bluetooth - Highline CCM + CECM - AF CAN Gateway - Cornering Fogs - U.S Indicators

Offline daboy3000

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 8
  • -Receive: 9
  • Posts: 599
  • MKV GT TDi
Re: Advice needed for clock/dials removal HELP!!!!!!!!!
« Reply #7 on: April 13, 2011, 05:39:35 pm »
It gets worse, just had to drive home with no power steering, what have I done. Someone please help me
Logged

Offline vRStu

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 90
  • -Receive: 159
  • Posts: 2562
    • Octavia-vRS Information Resource
Re: Advice needed for clock/dials removal HELP!!!!!!!!!
« Reply #8 on: April 13, 2011, 06:01:24 pm »
The Power Steering issue will likely be related to the symbols on your dash insert.  It's highly likely you'll need to carry out a basic setting adaptation if it hasn't reset itself after a drive of a few yards.

Ideally you'll need access to VCDS for this.
Logged
Stu...

Quartz Grey Audi A4 3.0 TDi S-Line Quattro, 7 Speed S-Tronic, 19" Twin Spoke Alloys, Alcantara Upholstery with Silver Stitching and Heating, Sat Nav High, B & O Sound, Audi Music Interface, DAB Radio, Parking Advanced with Rear View Camera, Advanced Keyless Entry, LED Interior Light Pack, Hill Hold Assist, Heated and Electrically Folding Mirrors, Through Load.

RNS510 Video in Motion unlocking, PIN recovery & DVD Region Free available

Offline Eddie-NL

  • Trader - 2014
  • Just look at my post count
  • *
  • Thank You
  • -Given: 0
  • -Receive: 298
  • Posts: 2639
    • Email
  • My Ride: http://www.mk5golfgti.co.uk/forum/index.php/topic,56721.0.html
Re: Advice needed for clock/dials removal HELP!!!!!!!!!
« Reply #9 on: April 13, 2011, 06:02:38 pm »
you need to perform basic settings for the G85 and Abs sensors
Logged
Genuine VCDS VAG-COM HEX-USB + Genuine Vag Commander + Genuine VAG Tacho + Genuine VAG CAN PRO  + RNS Manager for Video in Motion and New Pin Code for RNS510


Cluster and Key coding

Location Great Yarmouth


Retrofits fitted by me see my members rides

Offline vRStu

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 90
  • -Receive: 159
  • Posts: 2562
    • Octavia-vRS Information Resource
Re: Advice needed for clock/dials removal HELP!!!!!!!!!
« Reply #10 on: April 13, 2011, 06:02:58 pm »
Logged
Stu...

Quartz Grey Audi A4 3.0 TDi S-Line Quattro, 7 Speed S-Tronic, 19" Twin Spoke Alloys, Alcantara Upholstery with Silver Stitching and Heating, Sat Nav High, B & O Sound, Audi Music Interface, DAB Radio, Parking Advanced with Rear View Camera, Advanced Keyless Entry, LED Interior Light Pack, Hill Hold Assist, Heated and Electrically Folding Mirrors, Through Load.

RNS510 Video in Motion unlocking, PIN recovery & DVD Region Free available

Offline daboy3000

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 8
  • -Receive: 9
  • Posts: 599
  • MKV GT TDi
Re: Advice needed for clock/dials removal HELP!!!!!!!!!
« Reply #11 on: April 13, 2011, 06:40:28 pm »
Cheers guys, got the power steering back on and the LCD, TCS light still on but thats not a big deal.

Big thanks to stu and I owe lee a drink!!
Logged

Offline apollo13

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 2
  • -Receive: 47
  • Posts: 1017
Re: Advice needed for clock/dials removal HELP!!!!!!!!!
« Reply #12 on: April 13, 2011, 07:44:18 pm »
No worries Ben,

Happy to help

If I know anyone that wants a lowline cluster I'll let you know  :happy2:
Logged
****Registered VCDS HEX CAN Kent Area For All Retrofits**** GT TDI - Retro fitted by me so far.... OEM Omanyts - Sportlines - GT Sport Front End - GTI Rear and Skirts - Hella Dynabeam Xenons - Heated Leather - Highline Cluster With White LED's and Lit Needles - Armrest - Mk6 GTI MFSW - Skyline OEM LED Tailights - LED RNS 510 With Voice Control - Rear Sensors - 729B Bluetooth - Highline CCM + CECM - AF CAN Gateway - Cornering Fogs - U.S Indicators
Pages: [1]   Go Up
« previous next »