Hi all have my first issue with the car
The car is a 2007 Ed30 DSG with just under 15k on it.
The following fault will clear but will come back after about 10 seconds of ignition on:
Address 01: Engine Labels: 06F-907-115-AXX.LBL
Control Module Part Number: 1K0 907 115 L HW: 8P0 907 115 B
Component and/or Version: 2.0l R4/4V TFSI 0030
Software Coding: 040300031C070160
Work Shop Code: WSC 66565 257 00032
VCID: 2F66E8C1C78D
1 Fault Found:
000406 - Engine Oil Temp. Sensor (G8): Implausible Signal
P0196 - 004 - No Signal/Communication
Freeze Frame:
Fault Status: 01100100
Fault Priority: 0
Fault Frequency: 1
Mileage: 23883 km
Time Indication: 0
Date: 2000.00.00
Time: 16:05:14
Freeze Frame:
RPM: 749 /min
Load: 18.0 %
Speed: 0.0 km/h
Temperature: 84.0°C
Temperature: 36.0°C
Absolute Pres.: 1010.0 mbar
Voltage: 13.843 V
Readiness: 0110 0101
If I look at the oil temp in measuring blocks, it always reads -60C. My understanding is that the oil temp is measured by the oil level sensor in the sump. Is this correct? When I look at oil level in measuring blocks its blank except for the level will flash up as 0 for a fraction of a second every 5 to 10 seconds.
I unplugged the sensor today and cleared the fault. After 10 seconds I got the same fault code.
There are no scrapes whatsoever on the sump or the sensor itself. The 3 wires going into the plug are secure and there is no corroding on the terminals.
Could it be anything else before I replace the sensor? Any comments/opinions welcome
Kevin