Fitted the R32 rear bumper & some LED rear lights on Sunday, they look great
But have a slight issue now. While removing the licence plate light/parking sensor connector (the main connector on the rear drivers side) I snapped the clip. So when putting it back in I used duct tape to hold it together and it looked fine. But after finishing I turned the ignition on and it came up with the light out warning and the licence plate light/rear parking sensors don't work, just get a long beep then nothing.
Reaching under the car I can feel the connector is still connected but I assume its not tight enough.
So is it an easy fix or not?
Will take a look tomorrow morning as am off. Maybe try and pull it tighter together with some cable ties for now?