Lean Fuel Issues after 4k rpm on Revo Stage 2+ Ed30

[tony_danza]

Fantastic spot Jonny!!

I have a feeling someone will be ripping his car apart into the wee hours tonight - fingers crossed it's that.

[jonnyc]

Fantastic spot Jonny!!

I have a feeling someone will be ripping his car apart into the wee hours tonight - fingers crossed it's that.

Well could end up not being that, but at the moment it looks very possible, I hope it is for Illyuns sake, so that he can get the car back on the road running full stage 2+ powerrrrrr haha..

[MAT ED30]

I am sure the new pipes had new o rings on them

[tony_danza]

The O-Rings can also pinch and tear, causing it to blow past - so if it turns out they are on, they could just be goosed? just a thought.

[jonnyc]

I am sure the new pipes had new o rings on them

I would have thought they would too, but in the pics earlier it doesnt look like it..

[illyun]

I am sure the new pipes had new o rings on them

Just gone out and come back and on the way, I thought I should ask you whether the new pipes had O-Rings as I couldn't remember.  What I don't get is that the new pipes were difficult to get on and were tightly inserted - we tugged them slightly to ensure the fit was secure.  If the new pipes didn't have the o-rings, then would they have fitted tightly... I'm going to scour my install pics... I really hope the O-Rings weren't on the new pipes 

[MAT ED30]

It does fella 100% sure as I will post a pic

[jonnyc]

It does fella 100% sure as I will post a pic

Ahh, well so much for that.. Worth a check anyways if the car is up on the ramp, would only take 5mins..

[MAT ED30]

[illyun]

Is that bottom ring on the right pipe an o-ring?   I remember tightening the screw when it was put on...

[MAT ED30]

Is that bottom ring on the right pipe an o-ring?   I remember tightening the screw when it was put on...

thats a jubilee clip u nut case  but the o ring is on the top of that pipe

[jonnyc]

s3

I can't see the o-ring in this pic, am I missing something??  .. Thats what Illyun has on his car now, could it be that this pipe didn't have an o-ring fitted??

[illyun]

Is that bottom ring on the right pipe an o-ring?   I remember tightening the screw when it was put on...

thats a jubilee clip u nut case  but the o ring is on the top of that pipe

So then there IS a problem right?  Because I put them on like that.... I did wonder why the S3 - with more power - had flimsier pipe connections than the Ed30 at the time 

Does there  have to be an o-ring on both ends of the S3 pipe like the red Ed30 one has?

[MAT ED30]

the pipe in my pic goes the other way around and the jubilee clip goes on the ic

[MAT ED30]

posh on end of pipe and clamp on