Here we go... this is
StevenW007s front badge.
You'll need.
1 VW badge
1 Strong knife
1 Very sharpe knife
1 Hair dryer (or gas hob if your brave)
1 piece of vinyl wrap in your choice of colour.
--------------------------------
1 by
Rich Wigley, on Flickr
First we need to detach the front. With a strong knife work between the chromed plastic and backing to prise the front away from the back.
2 by
Rich Wigley, on Flickr
You will get to the last one and it will be stiff. What you need to do now is flip the badge over and unclip the 2 clips in the centre of the badge.
3 by
Rich Wigley, on Flickr
Once you have done this the last clip around the edge will be easy to lift.
4 by
Rich Wigley, on Flickr
Get a suitable amount of wrap, in your preferred colour.
5 by
Rich Wigley, on Flickr
Carfully place it on the badge and get rid of any air bubbles.
6 by
Rich Wigley, on Flickr
Now, gently heat the edge of the wrap so it goes soft and ease the wrap over the edges of the chrome badge.
7 by
Rich Wigley, on Flickr
Trim edge of badge to leave about 1cm surplus
8 by
Rich Wigley, on Flickr
Make incisions from the corners to the middle of each hole. Fold the wrap back over. Use a heat source to soften the wrap to make it easier.
9 by
Rich Wigley, on Flickr
Should end up looking like this. Getting the bit between the V and the W and around the edge of the whole badge to stick is a pain
10 by
Rich Wigley, on Flickr
Press the wrapped VW badge back onto its backing.
11 by
Rich Wigley, on Flickr
DONE!