Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: Kenwood DNX in - Power issue  (Read 1087 times)

Offline Bikerz

  • Always Involved
  • ****
  • Thank You
  • -Given: 2
  • -Receive: 2
  • Posts: 182
    • Email
Kenwood DNX in - Power issue
« on: January 07, 2012, 09:01:53 pm »
I know its common on these.

I have a 56 plate GT TDI 170. The yellow and red leads are both 12V always and not switched. Do I need a control module or something to make it switched when I remove key so it turns off?
Also the DNX is a stock fit VW item, I ordered a double din faceplate which fits golf fine but not around DNX (Leave a little gap at bottom). Any ideas on this?
Logged

Offline SteveP

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 117
  • -Receive: 340
  • Posts: 6005
    • My Project
Re: Kenwood DNX in - Power issue
« Reply #1 on: January 07, 2012, 09:07:35 pm »
You get a 12v switched feed from the fuse box, there's plenty of unused pins in there  :happy2:

Was the double din face the original VW one as lots of the cheeper eBay copies are known for not fitting very well.
Logged

Offline Bikerz

  • Always Involved
  • ****
  • Thank You
  • -Given: 2
  • -Receive: 2
  • Posts: 182
    • Email
Re: Kenwood DNX in - Power issue
« Reply #2 on: January 07, 2012, 09:22:01 pm »
Face plate was just a ebay kit. ISO lead, Face plate and Ariel adaptor so guess I brought a duff one! Bollox!
Logged
Pages: [1]   Go Up
« previous next »