Make a donation

Author Topic: Changing side light bulb  (Read 3550 times)

Gazman1011

  • Guest
Changing side light bulb
« on: January 22, 2012, 03:37:27 pm »
Lads how do I change my side light bulb. I have looked and I can't get it out. Lol had my chubby hands in engine bay for agers. Lol. Thanks guys.

Offline apples12

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 6
  • -Receive: 34
  • Posts: 563
Re: Changing side light bulb
« Reply #1 on: January 22, 2012, 04:09:39 pm »
its a right b****** to change, whether you got the normal halogens and especially if you got the xenons, dont know what vw were thinking, but be careful, first twist the bulb holder then apply careful pressure tugging on the wire straaaaight out and not at an angle, should 'pop' out!

good luck

oh, and be prepared for bruised knuckles  :happy2:
MK6 GT TDI  - CW - LUX pack
GONE
MkV Golf 1.9TDI Sport in DBP, 160,000 miles and climbing!

Retrofits by me:GT front end,OEM bixenons with auto-levelling/washers, Valeo LED Rears, MFSW + Highline SWCM, Cruise Control, 30byte Highline CECM, Highline clocks, Rain/Light Sensor, Auto-dimming Rear view Mirror, RNS-510 LED (Ver H; SW: 4020), Fiscon Basic Bluetooth, MDI + Aux, Armrest, Reverse Camera LOW, TPMS..what next...

Gazman1011

  • Guest
Re: Changing side light bulb
« Reply #2 on: January 22, 2012, 04:41:29 pm »
I have got brused knuckles. Lol. Not impressed. A right a pain. I give up for the day. Lol. Not enough light. So packed in.

Offline Gene Hunt

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 59
  • -Receive: 61
  • Posts: 2478
    • Email
Re: Changing side light bulb
« Reply #3 on: January 22, 2012, 05:01:12 pm »
its a right b****** to change, whether you got the normal halogens and especially if you got the xenons, dont know what vw were thinking, but be careful, first twist the bulb holder then apply careful pressure tugging on the wire straaaaight out and not at an angle, should 'pop' out!

good luck

oh, and be prepared for bruised knuckles  :happy2:
...........don't think i would pull the wires to remove the holder :scared:. I just got hold of the holder as close to the rear of the headlight as poss & just rocked/tugged untill they come out.
« Last Edit: January 22, 2012, 05:55:22 pm by Gene Hunt »
ED35. Standard factory condition.

Offline Mandy

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 95
  • -Receive: 94
  • Posts: 1701
  • Drink Russian, Wear Italian, Drive German :)
Re: Changing side light bulb
« Reply #4 on: January 22, 2012, 05:23:01 pm »
I managed to do one side of mine pretty easily, just came straight out. The other side would not budge though so in the end had to use some long nosed pliers, grabbed hold of the holder and pulled straight out.

I wouldn't recommend pulling by the wires either. :scared:
................................................
Driving: Tornado Red MK7 GTD, BMW 330e
Drove: Rising Blue Golf 6R, Reflex Silver Edition30 No.1684, Tornado Red Mk5 Golf GTI

Offline Little_Dave

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 9
  • -Receive: 28
  • Posts: 921
Re: Changing side light bulb
« Reply #5 on: January 22, 2012, 05:38:58 pm »
I managed to do one side of mine pretty easily, just came straight out. The other side would not budge though so in the end had to use some long nosed pliers, grabbed hold of the holder and pulled straight out.

I wouldn't recommend pulling by the wires either. :scared:

Same as Mandy one side was easy to do with my hands but the other side needed needle nose pliers to wiggle it free, you'll be glad to know that putting the new ones in is alot easier and just push in and click into place  :happy2:

Dave

Gazman1011

  • Guest
Re: Changing side light bulb
« Reply #6 on: January 22, 2012, 05:40:19 pm »
If in doubt I'll take the while light out. Lol

Offline Little_Dave

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 9
  • -Receive: 28
  • Posts: 921
Re: Changing side light bulb
« Reply #7 on: January 22, 2012, 05:42:07 pm »
If in doubt I'll take the while light out. Lol

Think you might need to remove the bumper to access the bottom tab/screw holding the light in place or atleast loosen the bumper off to get to it  :confused:

Dave