Garage Vary Lip installed! (finally...)
Being so busy at work, really didn't have much time to install this over the past few weeks. Finally got around to it!
As is so often the case with well made JDM parts, there is perfect fitment... and this lip was no different.
I wasn't a fan of the lips that were on offer mainstream (e.g OSIR, kerscher, etc) so I decided to see what the JDM market has to offer. Tendy actually told me about how Garage Vary has parts offerings for the VW Golf R and Scirocco R platforms. After seeing his car, I bit the bullet.
Although the instructions were in Japanese, it's very simple to work out. The front lip has 5 holes and 5 screws which require you to screw the lip to the underside of the bumper to hold it in place. It also came with a very thin strip of double stick tape stuck towards the back of the lip where it's meant to hold the lip in place while you screw in the supplied screws through the 5 holes, but I decided this wasn't enough so I used some strong 3M double stick tape from Bunnings to hold it in place.
The lip fits the curvature of the middle part of the Golf R bumper very nicely. The lip did not need any bending or anything of the sort. It was just a matter of measure, peel, stick, screw, and done. Whole thing took roughly 30 minutes to install.
Unlike the Kerscher/EZ lip, this lip doesnt reduce the distance from the floor to the bumper as it's designed to fit in the middle part of the Golf R bumper where it slightly elevates. Not only that, it now compliments the OSIR Carbon Fibre mirror covers.
Enough rambling....here's the only decent photo I could get with my phone. Thanks again goes to Morph for giving me the contact who sent this over from Japan
