All Things Mk5 > Mk5 General Area
Volant Intake System for TFSI
Tamiyoman:
--- Quote from: donovan2123 on March 01, 2012, 06:06:38 pm ---I have had a response.
No plans for KO4 cars full stop from sounds of it! Although i reckon it would be to hard to adapt a kit for ko4.
The new 2.0TSi found in the new GTI is somthing there currently making and ETA is 8-12 weeks.
Also to answer the engine movment question there response is below
"We have sold 100's of intakes, tested on my personal car "2006 GTI" for over a year without any fitment or performance issues"
--- End quote ---
Did you mean "Although i reckon it would NOT be to hard to adapt a kit for ko4?"
Or is there no way?. I though inlet pipes were same?, diameter fitting etc?, or am I wrong?
Anyone?
donovan2123:
Well i dont have a ko4 so i am not 100% sure but i reckon a adaptor which adds a connection at the intake for you to put the rubber pipe would do the job.
I have seen these type of connectors before when trying to connect a boost guage to rubber, silicone or plastic which can not be tapped.
Tamiyoman:
I was just wondering if the intake port (where rubber pipe attaches from turbo to the Volant) is same size on K03 as K04?
donovan2123:
That i dont know. But im sure someone on here will no the answer.
blackmagic:
Also need to check that the pipe diameter were the MAF is the correct size otherwise will cause problems.
I'm currently looking into an intake and have been for ages but haven't found one that works for me yet. If you do get one keep us all updated with a small review / dyno results etc.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version