James GTI Ko4 2.0tfsi 401bhp - launch control?

[vRSAlex]

Most kits have their own wire that you can use as a cutout.  Not sure if your kit has that.

[Dan.b]

James did you get my pm/email?

Really sorry to post this in your thread but just need to know if you can help me out with the sensor.

Thanks. 

[h4rdy]

What happens if the meth stops for whatever reason full chat?

You can get it wired in to cut the N75.

you got any info on how to do that?

Sorry James missed that but it was Alex who told me anyway.

I know the AEM kit allows this, the one I will be getting, but as Alex says not sure.

You will be able to MAP it upto the Meth then

[DanGB]

I wouldnt rely on just the low fluid sensor to know if meth is working. My snow kit is working intermittantly at the moment. The tank is full though.

[james]

Yea might just buy a flow kit for it

[vRSAlex]

Had a look at the wiring info on the kit.  Doesn't have a specific wire that can be used.  Would have to go through the led.  Maybe fit a buzzer to the wire.  More noticeable than an led.

[james]

ok mate, thanks for your help.

[h4rdy]

James thanks for the HPFP, all rebuilt and running fine.

J

[paulmk5gti]

  very good read

[paulmk5gti]

hi james looking for a bit of advice i am replacing my bwa with golf R CDL engine would it be best to use all the sensors from my bwa engine? and then get a custom remap from r tech 

[james]

hi mate, you just need to install the G247 High Pressure Fuel Sensor and map sensor from your bwa then your be ready to go 

you can drive the car but dont give it any beans,  your just hear the engine loading due to the n75 request.

[paulmk5gti]

thanks james any other hints and tips lol 

[scopes]

hi mate, you just need to install the G247 High Pressure Fuel Sensor and map sensor from your bwa then your be ready to go 

you can drive the car but dont give it any beans,  your just hear the engine loading due to the n75 request.

Hey James

With the G247 High Pressure Fuel Sensor, are these different on say the ed30, s3, Cdl engines compared to the BWA ?

thanks

[james]

yep, the s3 g247 made my engine run lean.

It is do with the voltage they signal on,  bwa has one point and it seems the s3 has to points.


Tips.
Just change it on your drive! only took me 1.5 days on my own, really easily job 

[h4rdy]

The whole engine or just the G247

The G247 should take an hour and some 'modified' spanners.