Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: Edition 30 Stage 1 & ITG Maxogen Intake?  (Read 2343 times)

Offline George

  • Always Involved
  • ****
  • Thank You
  • -Given: 8
  • -Receive: 8
  • Posts: 331
    • Email
Edition 30 Stage 1 & ITG Maxogen Intake?
« on: April 16, 2012, 11:59:14 am »
Hi all,

I'm getting close to booking my Edition 30 in for it's stage 1 remap. I've been thinking about getting the ITG induction kit at the same time to compliment it. Has anyone fitted this with a stage 1 remap? If so what gains were shown? I've heard good reviews on the kit, especially gains wise but based on Stage 2 and Stage 2+ maps.

Also is it safe to fit the kit on the standard engine, I read something that said it could cause the engine to run lean?

Lastly, is there much difference seen MPG wise?

Thanks  :happy2:
Logged

Offline ktlstar

  • Always Involved
  • ****
  • Thank You
  • -Given: 3
  • -Receive: 10
  • Posts: 434
    • Email
Re: Edition 30 Stage 1 & ITG Maxogen Intake?
« Reply #1 on: April 16, 2012, 12:07:24 pm »
 few bhp+ just helps to let the turbo breath in a open filter then a restricted enclosed box.

I had it installed on stage1 remap however i wont quote the figures as it came from AMD unrealistc rollers.

Install it, it wont be a problem, and no it wont make the engine lean. MPG will be affected due to the remap+itg.
Logged
- #1240 ED30 Revo STAGE2+
- Southeast - Vag Com owner

Offline RussZS

  • Always Involved
  • ****
  • Thank You
  • -Given: 88
  • -Receive: 17
  • Posts: 325
    • Email
Re: Edition 30 Stage 1 & ITG Maxogen Intake?
« Reply #2 on: April 16, 2012, 01:02:04 pm »
I had it on mine too - MPG was down because the noise was addictive at first  :happy2:
Logged
www.midlandscarcare.co.uk - www.facebook.com/midlandscarcare

I used to be indecisive.......... but now I'm not so sure!

Offline Jussa

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 23
  • -Receive: 12
  • Posts: 1051
  • Bicester
    • Email
Re: Edition 30 Stage 1 & ITG Maxogen Intake?
« Reply #3 on: April 16, 2012, 02:03:09 pm »
Quote from: George on April 16, 2012, 11:59:14 am
Hi all,

I'm getting close to booking my Edition 30 in for it's stage 1 remap. I've been thinking about getting the ITG induction kit at the same time to compliment it. Has anyone fitted this with a stage 1 remap? If so what gains were shown? I've heard good reviews on the kit, especially gains wise but based on Stage 2 and Stage 2+ maps.

Also is it safe to fit the kit on the standard engine, I read something that said it could cause the engine to run lean?

Lastly, is there much difference seen MPG wise?

Thanks  :happy2:

It deffo makes a difference, and sounds like Darth Vaders under your bonnet  :laugh:
But if I was you I'd put the money towards a nice exhaust system to compliment the stage 1 map before investing in a CAI.
Just my pennies worth  :happy2:
Logged
2010 3dr phantom black S-Tronic S3 - BCS TBE with 3½" DP - LOBA LO4xx turbo - LOBA HPFP - Revo CAI - H&R 25mm lowering springs - Forge 11mm spacers - RS4 fuel Pressure valve - THS intercooler - H&R front and rear ARB's - AEM water methanol injection

spankydan

  • Guest
Re: Edition 30 Stage 1 & ITG Maxogen Intake?
« Reply #4 on: April 16, 2012, 04:58:17 pm »
Personally i would look to do all of the mods power wise and remap last as each different mod will alter the way in which the map will work and saves on additional remap costs - if you get charged for them.

Think of the ITG and Exhaust as a money saver - you get a better product that will last longer and in some cases of the exhausts a lifetime g'tee so never have to worry about shelling your own money out again :happy2:
Logged
Pages: [1]   Go Up
« previous next »