Author Topic: Re-drilling Wheel Hubs (Read 1025 times)

sideshowfred · « **on:** May 15, 2012, 05:52:52 pm »

I've got a set of wheels in my shed that I think would look rather good on my car. The only problem is there 5x100 fitment. I very much doubt the wheels themselves are suitable for re-drilling due to the design of them. So can the hubs and discs be re-drilled or would it be more hassle and cost than it's worth?
Any help much appreciated, Fred

fab5freddy · « **Reply #1 on:** May 15, 2012, 05:58:05 pm »

You need hub adapters mate, no need to go drilling anything

http://www.performancealloys.com/HUB-and-PCD-Adapters.aspx

sideshowfred · « **Reply #2 on:** May 15, 2012, 06:04:34 pm »

That was going to be my next question, but I didn't think you'd be able to get adaptor reducers haha. Just need to find £300 for a set now then

fab5freddy · « **Reply #3 on:** May 15, 2012, 06:09:04 pm »

Yeah there not cheap

Tfsi_Mike · « **Reply #4 on:** May 15, 2012, 06:12:05 pm »

If clearance wasnt an issue Id convert to 114.3mm and get some time attack wheels

Author Topic: Re-drilling Wheel Hubs (Read 1025 times)

sideshowfred

Re-drilling Wheel Hubs

fab5freddy

Re: Re-drilling Wheel Hubs

sideshowfred

Re: Re-drilling Wheel Hubs

fab5freddy

Re: Re-drilling Wheel Hubs

Tfsi_Mike

Re: Re-drilling Wheel Hubs