Make a donation
« previous next »
Pages: 1 [2]   Go Down

Author Topic: lamda sensor question  (Read 3853 times)

Offline chopper

  • Always Involved
  • ****
  • Thank You
  • -Given: 1
  • -Receive: 0
  • Posts: 137
Re: lamda sensor question
« Reply #15 on: May 31, 2012, 03:44:03 pm »
had a chat to Revo today and explained the situation. They said there was no problem with the map and didnt suggest there was another software version. They said the problem must be a faulty sensor? Would a faulty sensor take a reading at all? i dont know much about lamda sensors , but could it have been damaged during the exhaust installation?
Logged

Offline muckipup

  • Always Involved
  • ****
  • Thank You
  • -Given: 13
  • -Receive: 25
  • Posts: 419
Re: lamda sensor question
« Reply #16 on: June 01, 2012, 09:36:22 am »
I would have thought that with the rear lambda mapped out, it shouldn't matter if it was faulty or even removed and blanked off. Much as I love my Revo map, there is a little history with Revo blaming hardware as an initial response.

The ECU version issue is real...I had it!
Logged

Offline Thor

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 27
  • -Receive: 25
  • Posts: 713
Re: lamda sensor question
« Reply #17 on: June 01, 2012, 04:03:50 pm »
Quote from: muckipup on June 01, 2012, 09:36:22 am
I would have thought that with the rear lambda mapped out, it shouldn't matter if it was faulty or even removed and blanked off. Much as I love my Revo map, there is a little history with Revo blaming hardware as an initial response.

The ECU version issue is real...I had it!

It's like the default response with I.T support is to switch it off and on again  :signLOL:
Logged
Gone but not forgotten - Edition 30 No.2239
                                     Mk6 GTI
Pages: 1 [2]   Go Up
« previous next »