washer fluid bottle

[AA]

  Would like to fit the larger 5L bottle in place of the 3 or 3.5L bottle I have at the moment.
 Is there enough space to fit the larger bottle
  Is there a kind person who has the part number for the larger size pleeeese

[skard]

Yes it is a direct swap.

Try 1K0955453S fot the 5.5L reservoir.

If you don't have headlamp washers, you may need to buy a plastic plug and rubber washer.
When I bought the larger bottle when retrofitting headlamp washers, the headlamp washer pump hole was pre-drilled. You'll possibly need to plug it then.

431955465A - seal, can't remember PN for the plug - it is 22 & 26 on the diagram when you order.

[skard]

I recall my old reservoir having a few part number's that didn't correlate to a 5.5L one, to look at both the 3.6L and 5.5L look the same from the front, but the back end is deeper on the bigger bottle.

So if you're buying outwith the dealer then try get a picture.

[AA]

 Didnt expect a response so quickly and so helpful. Part numbers and ETKA diagram numbers.  
  Many thanks Mr SKARD
 I dont have washers as yet just gathering as much info as possible beforehand

[skard]

No probs.

Are you also fitting the low level sensor? This was part of the Kufatec lamp washer loom but can be put in seperately I believe.
Eddie-nl would be the man who could possibly make a loom for you.

[AA]

 Kufatec? Help (Im getting out of my depth)

[skard]

Sorry mate going off on a tangent.

Kufatec are a German firm who make retrofit looms, so if you know you are putting in headlamp washers or just the sensor warning then you may as well get the sensor/loom etc and do it all in one go. 

If you just want a bigger tank then ignore me!
It's this site you see, get an idea and watch it grow.

[AA]

   Found Kufatec. Spent the first couple of minutes looking at images before I found the
  Union Flag in the corner
   

[skard]

Have a search for Eddie-nl as he can make up some looms too