As i decided to get back at this build there were some parts sold some new so needed to decide in which way the build was going to be going. I sold mi southbend clutch and my CDL engine but now got another one and it was a complete with K04 turbo and I was thinking of keeping it with a stock turbo
but at the end decided to go big again. Other thing I will change is the gearbox. I'm probably going with the DSG DQ250, and that would be all
First thing I wanted to do is figure out the fueling system so I started with moving the fuel cell to the back of the car because in my country I have to have rear seats to be able to register the car and it's would be easier to fill up
So started with making a bracket that would hold in place the fuel cell
[img width= height= alt=IMG-20191130-210810" border="0]https://i.ibb.co/fFDWj4s/IMG-20191130-210810.jpg[/img]And this is the final product..
I haven't finished the lines and other stuff that are needed for the fueling because I need some parts that I will be ordering but for now I'm continuing my work with what I have ...
So out with the K04 and in with the manifold and the big one ...
Did some pipe work earlier but I did it From An F70 tubing and I thought it was a bit overrated so did one from an f63 tubing ...
Also started on the intake
changed the S3 injectors for the RS4 ones
[img width= height= alt=IMG-778faa71043e88cdac0c9e8f068c93ce-V" border="0]https://i.ibb.co/djS1DR6/IMG-778faa71043e88cdac0c9e8f068c93ce-V.jpg[/img]One of my biggest concerns was the rear drive axle because if I cut and weld it to size there is no one in my country that could balance it so I tried combining and found a solution. Front pice from an MK5 R32 and the back longer one from an MK1 Audi TT
That's all for now but will keep you posted
