MKV K03 advice

[Just_quietly]

Hey guys.
Just want to clarify some numbers.
I have a stage 2+ GTI. I recently got it dyno'd (maha). Results were 272hp. Is that all I can expect. My mechanic checked for boost leaks but there are none. I'm running 98 RON in Sydney AUS.
Note: the mechanic has a stage 2+ APR K03 MKV GTI getting 270hp. I'm a bit confused because revo have told me I should be getting 290-300hp on a K03.
Any comments are appreciated.
Cheers

[edd666999]

Realistically? 270 - 285bhp.

depending on if you have done more of the unneeded mods like de cat, fmic, rs4 valve.

[edd666999]

look here:

http://www.jkm.org.uk/performance/GalleryRollingroad.htm

should be a good few 2+ K03's in there

[Just_quietly]

Mods are FMI, rs4 valve but that doesn't improve performance more for fuel safety supply, TBE with a 200cel cat, autotech pump, full cold air intake, Forge diverter valve. The car runs well but I can't see her getting 290-300?

[edd666999]

Mods are FMI, rs4 valve but that doesn't improve performance more for fuel safety supply, TBE with a 200cel cat, autotech pump, full cold air intake, Forge diverter valve. The car runs well but I can't see her getting 290-300?

nor can i.

[Just_quietly]

look here:

http://www.jkm.org.uk/performance/GalleryRollingroad.htm

should be a good few 2+ K03's in there

Thanks for that. I found a couple. My car is making a bit more than there's so that looks promising.
Cheers

[PDT]

The peak number is relatively unimportant, post the dyno graph. After all, how often are you at peak RPM under full throttle?

[Just_quietly]

This is when I was stage 2 only. I've since put the pump on. I will post stage 2+ soon.

[Just_quietly]

And this is current stage 2+ on 98RON
B7T5F6. 272hp 396nM torque. We love our torque in OZ. I'm a bit shocked I didn't crack 400nM.







RUN 2

[drsilviuro]

This is my dyno at stage 2+



mods: s3 IC, APR hpfp, rs4 valve, ITG intake, full milltek 200 cell cat

[JMP]

This is my dyno at stage 2+

mods: s3 IC, APR hpfp, rs4 valve, ITG intake, full milltek 200 cell cat

Nice. What revo settings are you using?

[Just_quietly]

I wish mine would look like that.

[drsilviuro]

This is my dyno at stage 2+

mods: s3 IC, APR hpfp, rs4 valve, ITG intake, full milltek 200 cell cat

Nice. What revo settings are you using?

959

[Just_quietly]

This is my dyno at stage 2+

mods: s3 IC, APR hpfp, rs4 valve, ITG intake, full milltek 200 cell cat

Nice. What revo settings are you using?

959

How do you run 959??
If I ran a 9 boost, I would blow a turbo and running 9 fuel would be a lean setting for me. Do have methanol?

[drsilviuro]

This was the best setting after many logs. Timing pull almost zero and everything matches with requested.
I run 98 ron pump gas. No wmi.