Engine Warning Light - problem found and help needed

[bacillus]

A worn down A revision cam should feel smooth but the lobe height would be reduced leading to the discrepency between requested and actual rail pressure.

[johnhol78]

Logs redone and this time with block 103.

Car was fine this time. No major power loss.

https://docs.google.com/file/d/0B9iyWw-ZADAfc3hlWEpIeGJ2c1U/edit

nightmare when it's intermittent

[johnhol78]

Well bought new thrust sensor and was fitting it when I noticed the bajlnjo joint was wet. Looks like I did tighten properly when I changed the cam follower. Slightly embarrassed. Just hope that was the issue.

[bacillus]

Don't overtighten it!

If it's still leaking after tightening then I suggest you replace both the brass hpfp fitting and bolt.

[johnhol78]

Don't overtighten it!

If it's still leaking after tightening then I suggest you replace both the brass hpfp fitting and bolt.

Seemed ok, car was very responsive though EML came back on. Haven't checked code yet. Will do in a bit.

Seriously considering selling up and getting an ST. Nothing but issues.