Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: Problems after fitting intake  (Read 840 times)

Offline ashw831

  • Always Involved
  • ****
  • Thank You
  • -Given: 11
  • -Receive: 0
  • Posts: 133
    • Email
Problems after fitting intake
« on: August 13, 2012, 09:25:08 pm »
I fitted a pipercross filter to the join on the end of the air box and removed the standard filter.  Although when I go WOT there is a bit of an improvement in pick up and noise, when I am cruising at any constant speed the car seems to hesitate ( as if it was misfiring) I changed my plugs last week and it had the coil pack recall last year.
Has anyone got any suggestions as to why I am getting this issue please?
Thanks
Logged

Offline bacillus

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 4
  • -Receive: 451
  • Posts: 6329
Re: Problems after fitting intake
« Reply #1 on: August 13, 2012, 10:06:46 pm »
The sides of panel air filter seals the enclosure so simply removing it means you have an air leak. Don't know if this has a bearing on your issue as the leak is before the maf.
Logged
Without traction power is nothing!

Offline 56OctyVRS

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 39
  • -Receive: 72
  • Posts: 1003
Re: Problems after fitting intake
« Reply #2 on: August 14, 2012, 12:38:15 am »
You should have a seal to fit around where the oe panel filter goes to stop air leaking. If not you can use the oe filter and cut out the paper filter leaving the seal and use that.
Logged
Frozen White Ford Focus 1.6 Ecoboost Titanium.
Mods so far - Superchips Bluefin, High Flow Air Box

Offline ashw831

  • Always Involved
  • ****
  • Thank You
  • -Given: 11
  • -Receive: 0
  • Posts: 133
    • Email
Re: Problems after fitting intake
« Reply #3 on: August 14, 2012, 06:33:52 am »
Ahh, thank you guys! I will try an find it in the bin :-/
Logged
Pages: [1]   Go Up
« previous next »