Make a donation

Author Topic: issues with opening bonnet?  (Read 718 times)

Offline theo91

  • Always Involved
  • ****
  • Thank You
  • -Given: 6
  • -Receive: 0
  • Posts: 56
issues with opening bonnet?
« on: August 05, 2012, 01:32:58 pm »
i was trying to open my bonnet this morn to change the bulbs and my bonnet release handle snapped. i then removed the trim to pull on the actual cable itself but it still wouldnt release. does anyone know why this might be??? ..........and have a partnumber for the little plastic bit that connects the handle and cable  :signLOL:

Offline wacky

  • Always Involved
  • ****
  • Thank You
  • -Given: 56
  • -Receive: 4
  • Posts: 218
Re: issues with opening bonnet?
« Reply #1 on: August 29, 2012, 01:51:26 pm »
getting mine done tomorrow at VW, they quoted me £78 for the new handle fitted. the cable is ok.

Offline mvb12

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 15
  • -Receive: 64
  • Posts: 1539
  • VCDS - Adaptations * Coding * Diagnostics PM Me
    • Email
Re: issues with opening bonnet?
« Reply #2 on: August 29, 2012, 02:00:30 pm »
getting mine done tomorrow at VW, they quoted me £78 for the new handle fitted. the cable is ok.

 :signLOL: no more to be said
VCDS HEX NET / VCP / ODIS - COVERING LONDON AND MIDLANDS
VCDS - Adaptations * Coding * Diagnostics PM Me
Canbus Gateway - Supply and fit (Stop battery drain issues)

Offline ashley

  • Always Involved
  • ****
  • Thank You
  • -Given: 0
  • -Receive: 5
  • Posts: 104
    • Email
Re: issues with opening bonnet?
« Reply #3 on: August 29, 2012, 02:15:21 pm »
Handles snap due to the cable or closing mech seizing. Common problem always keep mine mega lubricated  :innocent:

There must be a procdure for getting the bonnet open should this happen. I would get some mole grips on the cable and giving it a proper yank with someone applying slight upward pressure to the bonnet front edge.