Make a donation

Author Topic: ITG intake fitment help?  (Read 1325 times)

Offline tommygti

  • Always Involved
  • ****
  • Thank You
  • -Given: 22
  • -Receive: 9
  • Posts: 445
    • Email
ITG intake fitment help?
« on: September 09, 2012, 07:18:14 pm »
Bought an itg maxogen intake. Managed fit the system without any problems or instructions and considering I was not supplied with the whole kit it was much simpler than I thought it would be. I have how ever run into a small problem. I cant seem to remove the two lugs that the heat shield supplied with the kit fits to. Any help?


Offline Hedge

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 484
  • -Receive: 304
  • Posts: 6621
Re: ITG intake fitment help?
« Reply #1 on: September 09, 2012, 07:22:34 pm »
If thats the back of the engine then they have non-captive nuts on the back. Don't bother to refit them.  :wink:

To turn the lugs either a socket, ring spanner or pipe/mole grips.

Offline bacillus

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 4
  • -Receive: 451
  • Posts: 6328
Re: ITG intake fitment help?
« Reply #2 on: September 09, 2012, 09:57:23 pm »
A Draper 38019 deep 24mm socket is what's needed...
Without traction power is nothing!

Offline JonnyF

  • Taking part
  • ***
  • Thank You
  • -Given: 0
  • -Receive: 3
  • Posts: 25
    • Email
Re: Re: ITG intake fitment help?
« Reply #3 on: September 10, 2012, 07:35:17 am »
Is that the two lugs that the rubber comes off and fits into the itg bracket and then pushes over them to keep it in place?

Sent from my HTC One S using Tapatalk 2