General > Product Reviews
LED Door Warning Lights - Review
GS WAX:
Urgent help needed please... I have repair wire 000 979 019 and it does not fit into the terminal block of the door controler, should they have to be forced in... This does not look very close to fitting.
Help please the car is in bits, I'm getting cold and want to go home.
fab5freddy:
They do fit, but will need gentle persuading. Check your putting it the right way in and gently push in, I used one of the misuses hair grips to push down until clicked into place.
Take your time, don't rush it, that's when things always go wrong :happy2:
GS WAX:
I failed....
The pin is bigger than the hole in the connector block,plus there is something, that i dont know what to call it(a square in one of the corners of the block), in the way, have pics on the iphone but bont know how to post them here, help again needed :happy2:
fab5freddy:
Which controller are you doing front or rear? Which Gen controller?
Which pin position on the block?
Upload pictures to photobucket, then copy and paste the image code in your post :happy2:
GS WAX:
--- Quote from: fab5freddy on February 07, 2013, 09:11:40 pm ---Which controller are you doing front or rear? Which Gen controller?
Which pin position on the block?
Upload pictures to photobucket, then copy and paste the image code in your post :happy2:
--- End quote ---
Car is a May2008 built ED30 3 door,
Started at passenger side door,
I Have this controller (btw Any idea as to what type of controller it is? GEN 3 min or max)
Trying to fit into pin numbers 18 and 19
The offending items
The repair wire just will not fit in that hole without butchering the connecter block.
Will call TPS in the morning to check they have supplied the correct part.
Cheers for the help so far
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version