Right, the cage thing that holds the gateway in place, does that move at all or does it stay put?
Can you not just disconnect the plug from the Canbus leaving the unit in place?That's what I'm going to try and do tonight as I had so many cuts on my hands last time I swapped over the Canbus
Ok I have managed to move the gateway out of the cradle but I dont seem to have any room to move the gateway past the cradle in any way.
Quote from: RoMocop on November 27, 2012, 03:45:19 pmOk I have managed to move the gateway out of the cradle but I dont seem to have any room to move the gateway past the cradle in any way. Did you try turning the gateway 90 degrees anti-clockwise then try to wiggle it down the right side of the cradle?
I Managed to get the plug off without removing the canbus All pluged in and I get the polar fis screen But when I try to set up any of the screens I just get a message saying " finding available parameters" and it won't do anything after that (left it 10 mins)
When you have finished to mount all the pieces, use a diagnosis software as for example Vag- com or another similar and follow the following steps:− − −-Connect with the 19-Gateway control module. -Within this module, access to Installation list . -Mark the module [75] Telematiks.Finally, make an Auto-Scan or review the rest of modules of your vehicle in order to erase the errors that have been generated because of disconnecting the battery and remove the connector of the vehicle Gateway.
Cheers mate I will have a look. Any more news on yours yet?