Well, I did some data logs today and I now need to figure out why my specified rail pressure never requests over 125bar when it's a 130 to 140bar remap...? My actual rail pressure is having no trouble staying a bit ahead of specified, so I think that there is nothing foul with the pumps(lpfp or hpfp), but still not eliminating the lpfp possibilities as I still haven't found the proper vcds adv. meas. block for it. My Lambda is fine and running rich b/c after about 4k rpm the specified drops and the results<85%.(optimal power @ 85-95)
Also, before the runs, I turned back the boost so actual will be more in line with specified rather than leaving it behind. And, I replaced the hpfp high-pressure brass outlet fitting.
Lambda
act/spec.; 2k rpm to 7k rpm - 4th gear
1.05 1
1.03 1
0.99 0.95
0.95 0.91
0.92 0.91
0.88 0.91
0.88 0.91
0.91 0.92
0.93 0.94
0.94 0.94
0.97 0.94
0.95 0.95
0.95 0.95
0.96 0.95
0.89 0.88
0.85 0.85
0.84 0.86
0.84 0.85
0.83 0.84
0.81 0.84
0.82 0.84
0.83 0.84
0.84 0.84
0.84 0.85
0.83 0.85
0.86 0.85
0.82 0.84
0.81 0.84
0.8 0.82
0.73 0.81
0.77 0.8
0.77 0.79
0.77 0.79
0.77 0.79
0.78 0.8
0.79 0.8
rail pressure; 2k rpm to 7k rpm - 4th gear
spec./actual
69.79 68.82
73.82 77.53
77.07 79.64
80.61 81.96
83.86 84.04
87 88.34
89.67 91.63
92.42 93.83
95.1 97.31
97.19 100.16
98.64 101.62
99.8 100.76
100.61 102.36
101.37 103.2
102.1 102.51
102.59 103.62
103.11 104.56
103.69 104.71
104.13 105
104.37 105
104.45 104.54
104.47 105.26
104.47 105.99
104.47 102.35
104.47 106.97
104.47 107.83
104.47 109.08
104.47 106.39
104.47 109.45
104.47 109.85
104.99 125.31
107.51 132.55
110.83 136.15
114.83 133.67
118.62 136.24
122.41 136.24