"GOLFZILLA" .... 600+BHP Project... TSR Performance ....

[Pikey Motorsports]

sorry officer! usually get a £60 fine from experience, never really had much hassle on previous cars allthough this one is abit smaller then usual but ill give it ago

[Saintsteve]

sorry officer! usually get a £60 fine from experience, never really had much hassle on previous cars allthough this one is abit smaller then usual but ill give it ago

From experience? 

Ok , although it looks great but I wouldn't dream of leaving that on without risk of fines etc

[Pikey Motorsports]

had a fine or 2 over the years from previous small plates but never points

i agree the golf does look good with a smooth grille.. ill risk it for awhile and see what happens it dont get used much so might be okay for awhile lol

[taff-turbo]

i dont think its an endorsable offence but if persistant the dvla can withdraw the registration.....

[theo]

It's a non endorsable £60, but many traffic plod I know will take a photo of repeat offenders and they go to the DVLA

[Pikey Motorsports]

Wrapped the ITG Intake piping

Removed oil cap neck

BSH PCV revamp




made quite a difference for a couple of small mods 

[craig_t]

Wrapped the ITG Intake piping

Removed oil cap neck

BSH PCV revamp




made quite a difference for a couple of small mods 

I didn't know you could remove the oil cap neck. Looks so much better. Is it easy to do?

[craig_GTI]

Very nice edition! Couple of questions if you don't mind? Front plate looks so much better? Where's it from? What have you wrapped the intake piping in? Looks amazing? And +1 for the oil cap neck info.. Sorry for all the questions :) thanks in advance.. Craig.

[Pikey Motorsports]

cheers people

the plate was from a company online called zoogle i think..

the intake is wrapped in dei gold heatwrap available from demon-tweeks

and the oil cap neck.. just take your oil cap off put a clean cloth in and i just gave the kneck a tap with a set of heavy mole grips/light tap with a hammer etc

Cheers

[Pikey Motorsports]

Little busy today...

Forge twintercooler..



Heres a pic of how bad the drivers side intercooler hose fits  



So had to give it a trim  



And back on  



Lower grill out  



Forge Re-circulation vale

 

Milltek full turbo back non res, decatted!!



And relaxxxxxx 

[camfollower]

Looks great!  That's quite enough work for one Saturday!

[Pikey Motorsports]

Cheers and it sure was! twintercooler hose was a pain in the ass

[Dave J]

Woah, you have been busy! 

Good work - worrying fitment on that hose, but glad to see it trimmed up ok.

Would be grateful if you can put up a vid at some point - really wondering if to put a milltek on my ED30 or not. I think I will, but not sure if full system or just the catback.

I did it in stages on my old mkiv - fitting the DP was quite noticeable in performance, whereas fitting the catback first just gave it a bit of voice (well needed on the 1.8t).

Think yours must sound quite throaty now 

[benj1989]

Looks great soo far.

Sent from my LG-P920 using Tapatalk 2

[craig_GTI]

cheers people

the plate was from a company online called zoogle i think..

the intake is wrapped in dei gold heatwrap available from demon-tweeks

and the oil cap neck.. just take your oil cap off put a clean cloth in and i just gave the kneck a tap with a set of heavy mole grips/light tap with a hammer etc

Cheers

Thanks for the reply 

New updates look amazing!