All Things Mk5 > How to Guides / Troubleshooting
How To: Mk5 Heated Seats Retrofit
Gmac:
--- Quote from: doylebros on October 26, 2017, 08:56:06 pm ---I assume your only interested in the heated seats working and not the lumber or memory seat.
So with that in mind if you connect the two heaviest connector to a temporary fused supply you'll be able to check if there's a feed to the under seat modules, that would be my starting point.
--- End quote ---
I would like the lumber working and i don't have memory seats!
Gmac:
--- Quote from: jason_rmh on October 26, 2017, 10:56:16 pm ---I have gone back and checked my installation, I only had 3 wires at the fuse box.
Unless some of these wires make a 'pair' for a fuse Connection?
I would call richter sport to see if they can help shed some light on why the loom has changed?
Richer Sport are the UK contact for kufatec.
I'll look at some wiring diagrams tomorrow to try work it out.
--- End quote ---
Thanks Jason,
Yeh, i was thinking about giving them a call, should be fun!!! :rolleye:
Gmac:
Well, phoned richter today and they were basically no help!!! I explained about the loom perhaps being the same as a loom for memory seas and that i needed to find out what the 7 cables that I have did individually, they didn't know the answer and suggested that if they speak to kufatec, who they deal with all the time, they won't get an answer to my basic question of what cable does what!!! Useless and not very helpful!
They said i should fit them all and then take them out one by one to rule them out as to what cable would be for the memory! wtf!
Oh well!
Gmac:
Ordered up some fuses and piggyback fuses too
Gmac:
Piggy back fuses bought and fitted, had to get two normal and four minis. I’ve wired up the 4 permanent fuses (2 20amp, 2 30 amp). Also wired up the single ignition 15 amp. Activated in vcds, but measuring block 10 in module 9 says inactive, when I’ve turned on the seats, and been sat in the seat. Lumbar doesn’t work either.
So i’m going to wire up the other 2 15amp ignition wires, (will be 7 total wired to the fuse box!) and see if this helps...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version