NEED HELP!!! PLEASE!! No Power Steering

[russb94]

Hi guys!

I am new to this forum so go easy  

I have a Mk5 golf gti which i left to stand for around 3 months. When i came to start it the battery was dead so i jump started it. I was driving along there   was a few lights on. The steering light,  ABS, ESP and the tyre pressure light. i looked on forums and it said to do the left to right thing, when i did that i then it went to partial power steering grrr!!

I've since put it on bosch kts 670 diagnostics and it comes up with:-
steering angle sensor  fault (which wont clear)
steering end stop - basic settings not peformed/wrong (which wont clear)
and both rear wheel speed sensors (which will clear but come back)

any ideas? its driving me crazy!

[Matto]

Sounds like you need to perform the basic settings.

Have a look here and scroll down to basic settings. [http://wiki.ross-tech.com/wiki/index.php/VW_Golf_(1K)_Steering_Assist

A tip for doing the end stop setting, hold it on the stop lo her than stated. 20-30 is what worked for me.

[russb94]

A tip for doing the end stop setting, hold it on the stop lo her than stated. 20-30 is what worked for me.

I've tried this today and it didn't clear. Im not 100% sure on the

"If the 02546 - Steering Limit Stop 005 - No or Incorrect Basic Setting / Adaptation fault will not clear after driving the vehicle and completing the VW Golf (1K) Steering Assist procedure, increase the time in-between key cycles to 30 seconds or more."

what am I meant to do for 30 seconds?

Thanks Russ

[Eddie-NL]

try doing the basic settings

switch the engine off

start the engine > turn all the way to the left and hold > turn all the way to the right and hold > turn all the way to the left

[russb94]

try doing the basic settings

switch the engine off

start the engine > turn all the way to the left and hold > turn all the way to the right and hold > turn all the way to the left

i tried this but it didnt work :( i cant see what im doing wrong.

[Eddie-NL]

are you using vcds for this?

where are you located?

[russb94]

Yeah i am using vcds and its a proper one. When i click on/off/next it comes up with error and not availible to do the adjustments

im from malvern in worcestershire (about 40 miles south of birmingham)

[biffobear]

I think you will have to fix the wheel speed sensors before it will allow you to carry out basic settings.