Cdl engine swap

[scopes]

Turbo & Injectors?

[pd9264]

Yeah the lot. So I wid of thought it would of worked

[bacillus]

Turbo & Injectors?

iirc james found that the cdl engine needed different fuel mapping compared with his blown k04 bwa engine.

Perhaps you could ask Nick at R-Tech for more info as he did james mapping.

[pd9264]

Does anyone know the part number for the g247 sensor. Just wondering if I put the wrong one back in.

[vRSAlex]

You need your old G247 and old map sensor.

Fueling isnt that much different between the two so the new lump will still run fine.

Gimme a call tomorrow afternoon if you are still stuck.

[pd9264]

Yep iv done that mate. I'm gona wip the intake manifold of 2 mora and see if the cdl engine I bought has got the k04 injectors in. You never no they may of swapped them out when they sold me the engine. I hope not as I just sold my old ones.

[pd9264]

Iv checked the injectors and they are the right ones. I done a short video of what's happening. It revs to 5500rpm now and then plummet rapidly with backfires the lot. On th video I didn't let of or Chang gear. Any thoughts. I'm gona take it to aks in a couple of weeks anyway but just wana see if anyone has had a similier problem.

[scopes]

How does it drive after that happens?

Does it still drive normal of boost, could you keep doing the same thing over again?

[pd9264]

I haven't really kept my foot to the floor as it sounds terrible. Usally it does it and power cuts for a split second and jerks really bad then I let of. But It drives ok until I get upto 5500rpm then it will do the same. It's slowly letting me rev higher as on Thursday it would do it at 4000rpm.

[martziniuk]

Do you have it mapped for the new engine yet?

[scopes]

Did you ever get the part number for the g247 sensor?

[james]

that is odd.  mine was fine when I changed the g247.

I could still trash it but the car had lost power due to the compression ratio.

Mine never did that.  You need to do some logging dude could be fuel cut.

[pd9264]

Yep it's strange. It's gota be a sensor or a fuel cut. I need to get it scanned il just wait till Alex gets back I think.

[scopes]

G247 sensor from a 2006 BWA TFSI engine

BOSCH
06D 906 051A
BPK

[pd9264]

Cheers iv got the right g247 in then so it's not that. Just went out in it again and put my foot down and held it there this time I got cel and epc light on. Also it flashed on mfd that low oil pressure switch engine off immediately. Iv got plenty of oil in it.