Make a donation

Author Topic: Miltek dwn pipe question  (Read 1188 times)

Offline Toast

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 12
  • -Receive: 3
  • Posts: 779
  • Oot n By all the Keyboard Warriors
Miltek dwn pipe question
« on: August 12, 2009, 10:48:26 pm »
Quick question regarding the Miltek downpipe, I received mine today (Bought from JonnyC) Should there be a gasket that go's on the flange of the dwn pipe before mateing upto the turbo? Also where the best place to get the rubber bracket that the hanger's slot into?Miltek direct or someone else? :confused:


Thanks

Toast
Editon 30, no-0472-, 1/4mile 13.6sec@Crail-Giac 348bhp,345lbsft,Milltek tbe,s3 Cooler,Helix single mass clutch kit,Eibach Coilovers,Bsh Cold Air Intake , Autotech HPFP,s3 brakes,Speedline Turini's,Xenons

Offline Janner_Sy

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 62
  • -Receive: 113
  • Posts: 5392
Re: Miltek dwn pipe question
« Reply #1 on: August 12, 2009, 10:56:02 pm »
gasket will cost you less than 5 bucks from a stealership mate. ive still got my oem bracket, so surely you could use your original, if not buy from stealership, shouild only be cheap

Offline Toast

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 12
  • -Receive: 3
  • Posts: 779
  • Oot n By all the Keyboard Warriors
Re: Miltek dwn pipe question
« Reply #2 on: August 12, 2009, 10:58:21 pm »
Cool thanks for the info RE- Gasket :happy2:
Editon 30, no-0472-, 1/4mile 13.6sec@Crail-Giac 348bhp,345lbsft,Milltek tbe,s3 Cooler,Helix single mass clutch kit,Eibach Coilovers,Bsh Cold Air Intake , Autotech HPFP,s3 brakes,Speedline Turini's,Xenons