So this morning before work I gave the car a coat of SRP and Collinite 476s. The car wasn't in direct sunlight and the heat hadn't turned up yet. (6:00am)
I did the whole car and the wax was left to cure for 10/15 minutes thereafter.
Then at work I was showing a mate the new wing that Volkswagen replaced, in the car park. And I ran my finger across the panel and it felt rough, I then ran my finger over the rest of the body work (factory paint) and again it felt slightly rough.
It's almost as if the wax had melted in the heat (32 degrees) and the dusty particles from the car park had stuck to the car. Is this remotely possible or could it be something completely different? Never experienced this before.
Any help would be appreciated.