All Things Mk5 > How to Guides / Troubleshooting
BSH Catch tank alternative fit.
QD MBE:
I did, I didn't like the way you have to take 2 screws out and sandwich the plate between the slam panel (radiator support) and the chassis. Looks a bit wrong. The can also sits too high IMHO.
Janner_Sy:
was thhinking it looked like a good position i might try, but i want the twin take and reckon that would get in the way.
i think it'll be the same for anyone with evoms, ITG, VF engineering, forge twintake etc
QD MBE:
I think you could also turn the bracket upside down and fit the Catch can lower still.
RedRobin:
....
Dave, this is excellent Quality!! - Exactly the info I needed to know.
I assume then that the BSH kit's included hoses are long enough. And conversely could be shortened for a slightly different off side (driver's side) location.
:drinking:
QD MBE:
--- Quote from: RedRobin on August 22, 2009, 05:05:47 pm ---....
Dave, this is excellent Quality!! - Exactly the info I needed to know.
I assume then that the BSH kit's included hoses are long enough. And conversely could be shortened for a slightly different off side (driver's side) location.
:drinking:
--- End quote ---
The supplied hose is about 4 ft long, you just cut the 2 hoses to the required length from that.
I will still fit OEM style clamps (the heater hose type) when I can get to the stealers.
:happy2:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version